State / Province *
Timing Belt Pulley Design Information
Prototype or Production
Plating / Coatings Available
Plating / Coating Information
Pitch / Profile
Tooth ranges we are able to manufacture for pitch/profiles available are listed above.
- 5mm HTD, (17 Tooth through 200 Tooth)
- 5mm PowerGrip GT, (16 Tooth through 200 Tooth)
- 8mm HTD, (14 Tooth through 140 Tooth)
- 8mm PowerGrip GT2, (22 Tooth through 140 Tooth)
- 8mm PolyChain GT, (14 Tooth through 140 Tooth)
Pulleys can be made to any belt width, and a belt can be supplied to match giving you total customization. Standard widths are listed above for the available pitch/profiles.
- 5mm HTD (9mm, 15mm, 25mm)
- 5mm PowerGrip GT (9mm, 15mm, 25mm)
- 8mm HTD (20mm, 30mm, 50mm, 85mm)
- 8mm PowerGrip GT2 (20mm, 30mm, 50mm, 85mm)
- 8mm PolyChain (12mm, 21mm, 36mm, 62mm)
~If a hub is required then the following needs to be INDICATED
Hub Required For Spacing
In a two pulley system at least one pulley needs to be flanged (we always flange the smaller of the two).
Unless noted, tolerances will be based on standard specifications.
Unless noted, tolerances will be based on standard specifications